LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Suction Hose Replacement (LB7 w/Denso) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the suction hose to the vehicle using new sealing washers.
  2. Install the suction hose to the accumulator.
    NOTE: Refer to FASTENER NOTICE .
  3. Install the NEW suction hose nut to the accumulator.

    Tighten 

    Tighten the nut to 16 N.m (12 lb ft).

    4. Fig 1: Suction Hose & Nut
    G01479002Courtesy of GENERAL MOTORS CORP.
  4. Install the suction hose to the compressor (1).
  5. Install the NEW suction hose mounting bolt (3).

    Tighten 

    Tighten the bolt to 16 N.m (12 lb ft).

  6. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging .
  7. Leak test the fittings to the component using the J 39400-A. 
Fig 2: Suction Hose & Mounting Bolt
G01479003Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals