LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Hose Replacement - Inlet (L18) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 GMC Sierra, 2003 GMC Cab & Chassis Sierra, 2003 Chevrolet Silverado, and 2003 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Drain the cooling system. Refer to DRAINING AND FILLING COOLING SYSTEM .
  2. Remove the air intake tube.
  3. Remove the heater and surge tank hose from the mounting clip.
  4. Using the J 43181  disconnect the heater hose from the heater core inlet.
    1. 4.1. Install the J 43181  to the heater core pipe.
    2. 4.2. Close the tool around the heater core pipe.
    3. 4.3. Firmly pull the tool into the quick connect end of the heater hose.
      Fig 1: Disconnect Heater Hose From Heater Core Inlet Using J 43181
      G01479047Courtesy of GENERAL MOTORS CORP.
    4. 4.4. Firmly grasp the heater hose. Pull the heater hose forward in order to disengage the hose from the heater core.
  5. Remove the inlet heater hose (1) from the engine coolant inlet fitting.
  6. Remove the inlet heater hose.
    Fig 2: Remove Inlet Heater Hose
    G01479048Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals