LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1599 (Power Sun Roof) >> Repair Instructions >> Sunroof Sunshade Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Track Slot, Retaining Tabs And Sunshade
    GM757742Courtesy of GENERAL MOTORS CORP.
  1. Position the sunshade to the vehicle from the top of the vehicle.
  2. Install the retaining tabs on one side of the sunshade into the track slot of the sunroof.
  3. Flex the center of the sunshade (2) upwards while simultaneously inserting the retaining tabs (3) into the track slot (1).
  4. Ensure that the sunshade tabs are fully seated in the track slots, and the sunshade slides smoothly.
    5. Fig 2: Identifying Water Trough-To-Sunroof Assembly Screws
    GM594496Courtesy of GENERAL MOTORS CORP.
  5. Install the water trough to the sunroof from the top of the vehicle.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the screws that retain the water trough to the sunroof.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

  7. Install the glass panel. Refer to Sunroof Glass Panel Replacement .
scientia non olet · About LEMON Manuals