Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Mark the location of the luggage carrier slats on the roof with masking tape.

Fig 1: View Of Luggage Carrier Slats

Courtesy of GENERAL MOTORS CORP.

Use tape to protect the mounting surface during removal.
To remove the luggage carrier slats, heat the slats using J 25070 . Apply heat in a circular motion for 30 seconds.

NOTE: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.

Use a plastic, flat-bladed tool to lift or remove the slats from the vehicle.
Remove the luggage carrier slats from the vehicle.
When replacing the slats, remove all of the adhesive using a 3M™ Scotch Brite molding adhesive remover disk, 3M™ P/N 07501 or equivalent.