LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Seat Belt Side Buckle Replacement - Rear (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • When installing the center seat belt anchor to the seat belt buckle/anchor plate assembly, ensure that the center seat belt webbing is not twisted.
  • Ensure that the center seat belt anchor is properly indexed between the locating tangs on the seat belt buckle/anchor plate assembly.
  1. Position the center seat belt anchor to the seat belt buckle and anchor plate assembly.
    Fig 1: View Of Rear Seat Belt Side Buckle
    GM753725Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the center seat belt anchor bolt that retains the center seat belt anchor to the seat belt buckle/anchor plate assembly. Tighten the bolt finger tight.
  3. Position the seat belt buckle/anchor plate assembly to the rear seat back hinge bracket.
  4. Install the left rear seat back rear mounting nut that retains the left seat back to the floor panel.

    Tighten: 

    • Tighten the rear seat back rear mounting nut to 45 N.m (33 lb ft).
    • Tighten the center seat belt anchor bolt to 50 N.m (37 lb ft).

  5. Return the rear seats to the passenger position.
scientia non olet · About LEMON Manuals