Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the seat belt side buckle (1) to the seat with the seat belt anchor nut (2).
Tighten: Tighten the seat belt side buckle nut to 55 N.m (40 lb ft).

Fig 1: Removing/Installing Seat Back Hinge Cover Retaining Screws
Courtesy of GENERAL MOTORS CORP.
Install the inboard rear seat back cushion latch cover with 3 screws.
Tighten: Tighten the rear seat back cushion latch cover screws to 2 N.m (18 lb in).

Fig 2: Identifying Seat Belt Side Buckle & Retaining Nut
Courtesy of GENERAL MOTORS CORP.