LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 2 Left Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt retractor assembly to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat belt retractor assembly to the vehicle.

    Tighten:  Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).

    Fig 1: Removing/Installing Rear Seat Belt Lower Anchor Nut
    GM830745Courtesy of GENERAL MOTORS CORP.
  3. Install the left rear quarter trim panel. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TRAILBLAZER, ENVOY, BRAVADA) or TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TRAILBLAZER EXT, ENVOY XL) in Interior Trim.
  4. Install the rear seat belt lower anchor nut. Ensure that the seat belt webbing is not twisted.

    Tighten:  Tighten the rear seat mounting nut to 45 N.m (33 lb ft).

  5. Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.

    Tighten:  Tighten the bolt to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals