LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Center Rear (TrailBlazer, Envoy and Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat belt retractor bracket on the seat back frame.
    Fig 1: Removing/Installing Seat Belt Retractor Bracket
    GM757367Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the seat belt retractor bracket bolt (1) to the bracket and seat back frame.

    Tighten:  Tighten the seat belt retractor bracket bolt to 55 N.m (40 lb ft).

    Fig 2: Locating Seat Belt Retractor Bracket Bolt
    GM753559Courtesy of GENERAL MOTORS CORP.
  3. Position the seat belt retractor assembly onto the seat back frame.
  4. Install the push pin on the seat back retractor to the seat back frame.
  5. Install the rear seat belt center retractor nut.

    Tighten:  Tighten the rear seat belt center retractor nut to 35 N.m (26 lb ft).

    Fig 3: Removing/Installing Rear Seat Belt Center Retractor Retaining Nut
    GM753557Courtesy of GENERAL MOTORS CORP.
  6. Install the seat belt into the retractor bracket by guiding the belt through the slot in the bracket.
    Fig 4: Removing/Installing Seat Belt At Retractor Bracket
    GM757364Courtesy of GENERAL MOTORS CORP.
  7. Install the rear seat back pad and cover. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) or SEAT CUSHION COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT, ENVOY XL) in Seats.
  8. Install the rear seat back seat belt bezel onto the seat belt.
  9. Install the seat belt bezel to the seat back.
    Fig 5: Removing/Installing Center Seat Belt Bezel
    GM753736Courtesy of GENERAL MOTORS CORP.
  10. Install the seat back bezel push pins.
    Fig 6: Locating Plastic Retainer Buttons On Rear Seat Belt Bezel
    GM753728Courtesy of GENERAL MOTORS CORP.
  11. Install the rear seat belt anchor to the seat belt buckle bracket with the nut.

    Tighten:  Tighten the rear seat belt anchor nut to 50 N.m (37 lb ft).

    Fig 7: View Of Rear Seat Belt Anchor Nut
    GM753723Courtesy of GENERAL MOTORS CORP.
  12. Install the rear seat back assembly. Refer to SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, EXT, ENVOY XL) or SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) in Seats.