LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Center Rear (TrailBlazer EXT, Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 screws securing the inboard rear seat back cushion latch cover.
    Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear seat belt anchor nut (2) securing the seat belt (1) to the seat frame.
    Fig 2: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  3. Pull the seat back cover and pad up to expose the seat belt bracket bolts. Refer toSEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) or SEAT CUSHION COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT, ENVOY XL) .
  4. Remove the 2 bolts (2) securing the seat belt bracket (1) to the seat back frame.
    Fig 3: Removing/Installing Seat Belt Bracket Mounting Bolts
    GM828222Courtesy of GENERAL MOTORS CORP.
  5. Remove the nut (1) securing the retractor assembly (2) to the seat back frame.
    Fig 4: Removing/Installing Retractor Assembly Mounting Nut
    GM828220Courtesy of GENERAL MOTORS CORP.
  6. Remove the retractor assembly.
scientia non olet · About LEMON Manuals