Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the nut (1) securing the retractor assembly (2) to the seat back frame.
Tighten: Tighten the center seat belt retractor mounting nut to 55 N.m (40 lb ft).

Fig 1: Removing/Installing Retractor Assembly Mounting Nut
Courtesy of GENERAL MOTORS CORP.
Install the seat belt bracket (1) to the seat back frame with the 2 bolts (2).
Tighten: Tighten the rear seat belt bracket mounting bolts to 35 N.m (26 lb ft).

Fig 2: Removing/Installing Seat Belt Bracket Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Install the seat back cover and pad to the seat back. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) or SEAT CUSHION COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT, ENVOY XL) .
Install the seat belt (1) to the seat frame with the rear seat belt anchor nut (2).
Tighten: Tighten all rear center seat belt anchor nut to 60 N.m (44 lb ft).

Fig 3: Identifying Rear Seat Belt & Anchor Nut
Courtesy of GENERAL MOTORS CORP.
Install the inboard rear seat back cushion hinge cover with 3 screws.
Tighten: Tighten the rear seat back cushion hinge cover screws to 2 N.m (18 lb in).

Fig 4: Identifying Seat Belt Side Buckle & Retaining Nut
Courtesy of GENERAL MOTORS CORP.