Installation Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear seat belt retractor assembly to the vehicle.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the bolts which retain the rear seat belt retractor assembly to the body.
Tighten: Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).
- Install the rear quarter lower trim, left or right side. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TRAILBLAZER, ENVOY, BRAVADA) or TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TRAILBLAZER EXT, ENVOY XL) , or to TRIM PANEL REPLACEMENT--REAR QUARTER--RIGHT (TRAILBLAZER, ENVOY, BRAVADA) or TRIM PANEL REPLACEMENT - REAR QUARTER - RIGHT (TRAILBLAZER EXT, ENVOY XL) in Interior Trim.
- Install the rear seat belt floor anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt floor anchor bolt to 70 N.m (52 lb ft).
- Install the anchor bolt cover.
- Install the rear quarter upper trim, left or right side. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER UPPER (TRAILBLAZER, ENVOY, BRAVADA) in Interior Trim.
- Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt upper guide bolt to 70 N.m (52 lb ft).