LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the child restraint tether anchor to the floor with the pivot point of the anchor ring indexed toward the front of the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the bolt that retains the child restraint tether anchor to the floor panel.

    Tighten:  Tighten the child restraint tether anchor bolt to 35 N.m (26 lb ft).

    Fig 1: Locating Rear Anchors
    GM744907Courtesy of GENERAL MOTORS CORP.
  3. Close the liftgate.
scientia non olet · About LEMON Manuals