LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the child tether anchor (2) to the seat cushion frame with the bolt (1).

    Tighten:  Tighten the child restraint tether anchor bolt to 35 N.m (26 lb ft).

    Fig 1: Locating Child Tether Anchor & Mounting Bolt
    GM828233Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the seat cushion. Refer to SEAT CUSHION TRIM PANEL REPLACEMENT - REAR NO.1 (TRAILBLAZER EXT, ENVOY XL) .
  3. Install the seat in the vehicle. Refer to SEAT REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT, ENVOY XL) .