Installation Procedure
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Install the seat belt buckle/anchor plate to the vehicle.
- Install the clip(s) that retain the seat belt buckle/anchor plate to the latch bracket.
- Adjust the left seat back to a cargo position.
- Adjust the seat filler panel in order to access the center rear seat back bracket/seat belt buckle anchor plate.NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the center seat back/seat belt buckle mounting nut.
Tighten
Tighten the center rear seat back mounting nut to 45 N.m (33 lb ft).
- Return the seat to an upright position.