LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1595 (Body Rear End) >> Repair Instructions >> Handle/Striker Replacement - Lift Gate Window >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the handle and striker assembly to the lift gate window.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the nuts retaining the striker assembly to the lift gate window.

    Tighten 

    Tighten the nuts to 6 N.m (53 lb in).

    3. Fig 1: Handle And Striker Assembly To Lift Gate Window
    G01642198Courtesy of GENERAL MOTORS CORP.
  3. Check the lift gate window for proper operation, adjust if necessary. Refer to STRIKER ADJUSTMENT - LIFT GATE WINDOW  .
scientia non olet · About LEMON Manuals