LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1594 (Interior Trim) >> Repair Instructions >> Assist Handle Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the bezels to the headliner.
  2. Rotate the bezels in order to seat the bezel retaining tabs above the headliner.
  3. Install the front and rear roof panel tabs into the bezels.
    4. Fig 1: Front And Rear Roof Panel Tabs Into Bezels
    G01642088Courtesy of GENERAL MOTORS CORP.
  4. Ensure the top of the roof panel tab (2) is positioned over the plastic retaining tab (1).
    5. Fig 2: Top Of Roof Panel Tab Is Positioned Over Plastic Retaining Tab
    G01642089Courtesy of GENERAL MOTORS CORP.
  5. Using a flat bladed tool, carefully push up on the bottom of the front roof panel tab (1) until fully seated.
    6. Fig 3: Push Up On Bottom Of Front Roof Panel Tab Until Fully Seated
    G01642090Courtesy of GENERAL MOTORS CORP.
  6. Using a flat bladed tool, carefully push on the bottom of the rear roof panel tab until fully seated.
  7. Close the bezel covers.
  8. Pull downward on the assist handle to ensure the handle is fully secured to the roof panel.
scientia non olet · About LEMON Manuals