Installation Procedure
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the seat on the floor studs. The seat should be in the folded position.
- Install the two rear nuts (2). Do not tighten the nuts.
- Unfold the seat to ensure that the seat latch (1) properly engages the latch bar (3) the floor.NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the front two rear seat mounting nuts (2).
Tighten
Tighten the front rear seat mounting nuts to 45 N.m (33 lb ft).
- Fold the seat to the stowed position.
- Tighten the two rear seat mounting nuts (2).
Tighten
Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).
- Install the communication interface module if installing the right-hand rear seat. Refer to COMMUNICATION INTERFACE MODULE REPLACEMENT (TRAILBLAZER, ENVOY & BRAVADA) or COMMUNICATION INTERFACE MODULE REPLACEMENT (TRAILBLAZER EXT & ENVOY XL) in Cellular Communications.