LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1593 (Seat System) >> Repair Instructions >> Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat cushion assembly to the vehicle.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.

    Tighten 

    Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).

    3. Fig 1: Rear Mount Trim Cover
    G01641875Courtesy of GENERAL MOTORS CORP.
  3. Install the hydraulic jack into the jack stowage area, on the left side only.
  4. Adjust the seat cushion assembly to the latched position.
  5. Install the rear mount trim cover.
scientia non olet · About LEMON Manuals