LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1593 (Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the two bolts (2) securing the rear seat cushion assembly (1) to the seat latch rod (3).
    2. Fig 1: Bolts Of Rear Seats Cushion Assembly
    G01641978Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear seat cushion assembly.
  3. Remove the pull handle assembly (1). Refer to PULL HANDLE ASSEMBLY REPLACEMENT - REAR NO. 2  .
  4. Remove the J-strips (2) securing the rear seat cushion cover to the seat cushion panel.
    5. Fig 2: Pull Handle Assembly
    G01641979Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat cushion panel from the pad and cover.
  6. Remove the hog rings (1) from the seat cover.
    7. Fig 3: Hog Rings From Seat Cover
    G01641980Courtesy of GENERAL MOTORS CORP.
  7. Carefully separate the hook and loop fastener strips (2) holding the cover to the pad.
  8. Remove the hog rings (1).
    9. Fig 4: Hog Rings
    G01641981Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals