Installation Procedure
WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- If the right seat back was removed, perform the following:
- 1.1. Position the right seat back to the vehicle.
- 1.2. Install the navigation control processor bracket, if equipped. Refer to NAVIGATION CONTROL PROCESSOR BRACKET REPLACEMENT (TRAILBLAZER, ENVOY & BRAVADA)
or NAVIGATION CONTROL PROCESSOR BRACKET REPLACEMENT (TRAILBLAZER EXT & ENVOY XL)
in Cellular Communication.NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- 1.3. Install the right front rear seat back mounting nut.
Tighten
Tighten the rear seat back mounting nut to 45 N.m (33 lb ft).
- 1.4. Tumble the right seat back in order to gain access to the right rear seat stud.
- 1.5. Install the right rear seat back mounting nut.
Tighten
Tighten the rear seat back mounting nut to 45 N.m (33 lb ft).
- 1.6. Return the right seat back to the upright position.
- Position the left seat back to the vehicle.
- Install the left 3 front seat back mounting nuts.
Tighten
Tighten the rear seat back mounting nuts to 45 N.m (33 lb ft).
- Tumble the left seat back in order to gain access to the left rear seat studs.
- Install the left 2 rear seat back mounting nuts.
Tighten
Tighten the nuts to 45 N.m (33 lb ft).
- Return the left seat back to the upright position.