LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1593 (Seat System) >> Repair Instructions >> Seat Back Hinge Replacement - Rear No. 1 (TrailBlazer, Envoy & Bravada) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially remove the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY & BRAVADA)  or SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT & ENVOY XL)  .
  2. Remove the latch release cables (1) from the latch release mechanism, located at the bottom of the seat back frame.
    3. Fig 1: Latch Release Cables
    G01641957Courtesy of GENERAL MOTORS CORP.
  3. Remove the head restraint release cable (2) from the left hand hinge bracket.
  4. Remove the bolts (2) that retain the latch bracket to the hinge bracket.
    5. Fig 2: Bolts Of Latch Bracket
    G01641958Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts (1) that retain the hinge bracket to the seat back frame.
  6. Remove the hinge bracket from the seat back frame.
scientia non olet · About LEMON Manuals