LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1593 (Seat System) >> Repair Instructions >> Seat Back Frame Replacement - Rear No. 1 (TrailBlazer EXT & Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screws from the inboard/outboard rear seat back cushion hinge covers.
    2. Fig 1: Screws From Inboard/Outboard Rear Seat Back Cushion Hinge Covers
    G01641945Courtesy of GENERAL MOTORS CORP.
  2. Remove the seat back cover and pad. Refer to SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY & BRAVADA)  or SEAT BACK COVER AND PAD REPLACEMENT - REAR NO. 1 (TRAILBLAZER EXT & ENVOY XL)  .
  3. Remove the push pins (1) securing the seat back panel to the frame.
    4. Fig 2: Push Pins Of Seat Back Panel
    G01641946Courtesy of GENERAL MOTORS CORP.
  4. Remove the seat back panel.
  5. Remove the rear center seat belt retractor assembly, if you are removing the frame from the left-hand rear seat. Refer to SEAT BELT SYSTEM or SEAT BELT SYSTEM in Seat Belts.
  6. Remove the seat back cushion mounting bolts (2) securing the rear seat back frame to the inboard/outboard rear seat back cushion hinge assembly.
    7. Fig 3: Seat Back Cushion Mounting Bolts
    G01641947Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals