LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Sunroof System & Luggage Carrier) >> Repair Instructions >> Luggage Carrier Slats Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: Apply the slats in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.
  1. Heat the mounting surface to approximately 27-41 °C (80-150°F).
  2. Ensure that the temperature of the slats is approximately 29-32°C (85-90°F).
    IMPORTANT: Do NOT touch the adhesive backing.
  3. Remove the backing from the adhesive on the slats.
  4. Align the luggage carrier slats with the masking tape.
  5. Install the luggage carrier slats to the vehicle.
    6. Fig 1: Installing Luggage Carrier Slats To Vehicle
    G01641681Courtesy of GENERAL MOTORS CORP.
  6. Apply equal pressure along the slats in order to uniformly bond the item to the mounting surface.
  7. Remove the masking tape from the vehicle.
scientia non olet · About LEMON Manuals