LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1587 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Trailblazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the rocker panel molding to the body.
  2. Install the 7 push-pins that retain the bottom of the rocker panel molding to the body.
    NOTE: Refer to Fastener Notice   in Cautions and Notices.
  3. Install the rocker panel molding bolts located at each end of the rocker panel molding.

    Tighten 

    Tighten the rocker panel molding bolts to 7 N.m (62 lb ft).

  4. Install the assist step. Refer to Assist Step Replacement   in Frame and Underbody.
  5. Install the front rocker molding scuff plate. Refer to ROCKER MOLDING SCUFF PLATE REPLACEMENT - FRONT   . 
    Fig 1: Positioning Rocker Panel Molding To Body (Trailblazer, Envoy, Bravada)
    G01641149Courtesy of GENERAL MOTORS CORP.
  6. Install the rear rocker molding scuff plate. Refer to ROCKER MOLDING SCUFF PLATE REPLACEMENT - REAR   . 
scientia non olet · About LEMON Manuals