Removal Procedure
WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition to the OFF position.
- Remove the right rear seat cushion. Refer to SEAT CUSHION REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) in Seats.
- Remove the communication interface module. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy, Bravada) or Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL) .
- Remove the navigation control processor bracket. Refer to Navigation Control Processor Bracket Replacement (TrailBlazer, Envoy, Bravada) or Navigation Control Processor Bracket Replacement (TrailBlazer EXT, Envoy XL) .
- Pass the cellular telephone coax cable through the carpet opening.
- Remove the seat back, left and right side. Refer to SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) or SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, EXT, ENVOY XL) in Seats.
- Remove the front door sill plates. Refer to DOOR SILL PLATE REPLACEMENT--FRONT .
- Remove the rear door sill plates. Refer to DOOR SILL PLATE REPLACEMENT - REAR (TRAILBLAZER, ENVOY, BRAVADA) or DOOR SILL PLATE REPLACEMENT - REAR (TRAILBLAZER EXT, Envoy XL) .
- Remove the center pillar trim panels. Refer to GARNISH MOLDING REPLACEMENT--CENTER PILLAR .
- Remove the rear quarter upper trim panels. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER UPPER in Interior Trim.
- Remove the lower rear quarter trim panels. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TrailBlazer, Envoy, Bravada) or TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TrailBlazer EXT, Envoy XL) , or to TRIM PANEL REPLACEMENT--REAR QUARTER--RIGHT (TrailBlazer, Envoy, Bravada) or TRIM PANEL REPLACEMENT - REAR QUARTER - RIGHT (TrailBlazer EXT, Envoy XL) .
- Remove the left coat hook. Refer to COAT HOOK REPLACEMENT In Interior Trim.
- Remove the tool kit carrier.
- Remove the child restraint tether anchors. Refer to CHILD RESTRAINT TETHER ANCHOR REPLACEMENT - Rear No. 1 (TrailBlazer, Envoy, Bravada) or CHILD RESTRAINT TETHER ANCHOR REPLACEMENT - Rear No. 1 (TrailBlazer EXT, Envoy XL) in Seat Belts.
- Lift and fold the carpet over the bucket seats.
- Remove the coax cable fasteners from the floor panel.
- Remove the coax cable fasteners from the left third pillar.
- Disconnect the coax cable (1) from the window mounted coupling.