LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1586 (Cellular Communication System) >> Repair Instructions >> Coaxial Cable Replacement - Cellular Telephone (Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the coax cable (1) to the window mounted coupling.
    Fig 1: Disconnecting/Connecting Coax Cable To Window Mounted Coupling
    GM826144Courtesy of GENERAL MOTORS CORP.
  2. Attach the coax cable fasteners to the left third pillar.
    Fig 2: Removing/Installing Coax Cable Fasteners In Third Left Pillar
    GM826148Courtesy of GENERAL MOTORS CORP.
  3. Attach the coax cable fasteners to the floor panel.
    Fig 3: Removing/Installing Coax Cable Fasteners In Floor Panel
    GM826146Courtesy of GENERAL MOTORS CORP.
  4. Position the carpet to the floor panel, aligning the holes in the carpet to the seat studs on the floor panel.
  5. Pass the cellular telephone coax cable through the carpet opening
  6. Install the child restraint tether anchors. Refer to CHILD RESTRAINT TETHER ANCHOR REPLACEMENT - Rear No. 1 (TrailBlazer, Envoy, Bravada) or CHILD RESTRAINT TETHER ANCHOR REPLACEMENT - Rear No. 1 (TrailBlazer EXT, Envoy XL) in Seat Belts.
  7. Install the tool kit carrier.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  8. Install the 3 tool carrier nuts to the floor studs.

    Tighten:  Tighten the nuts to 7 N.m (62 lb in).

  9. Install the lower rear quarter trim panels. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TrailBlazer, Envoy, Bravada) or TRIM PANEL REPLACEMENT - REAR QUARTER - LEFT (TrailBlazer EXT, Envoy XL) , or to TRIM PANEL REPLACEMENT--REAR QUARTER--RIGHT (TrailBlazer, Envoy, Bravada) or TRIM PANEL REPLACEMENT - REAR QUARTER - RIGHT (TrailBlazer EXT, Envoy XL) .
  10. Install the rear quarter upper trim panels. Refer to TRIM PANEL REPLACEMENT - REAR QUARTER UPPER in Interior Trim.
  11. Install the center pillar trim panels. Refer to GARNISH MOLDING REPLACEMENT--CENTER PILLAR .
  12. Install the left coat hook. Refer to COAT HOOK REPLACEMENT In Interior Trim.
  13. Install the rear door sill plates. Refer to DOOR SILL PLATE REPLACEMENT - REAR (TRAILBLAZER, ENVOY, BRAVADA) or DOOR SILL PLATE REPLACEMENT - REAR (TRAILBLAZER EXT, Envoy XL) .
  14. Install the front door sill plates. Refer to DOOR SILL PLATE REPLACEMENT--FRONT .
  15. Instal the seat back, right and left side. Refer to SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) or SEAT BACK REPLACEMENT - REAR NO. 1 (TRAILBLAZER, EXT, ENVOY XL)
  16. Install the navigation control processor bracket to the floor panel. Refer to Navigation Control Processor Bracket Replacement (TrailBlazer, Envoy, Bravada)  or Navigation Control Processor Bracket Replacement (TrailBlazer EXT, Envoy XL) .
  17. Install the right rear seat cushion. Refer to SEAT CUSHION REPLACEMENT - REAR NO. 1 (TRAILBLAZER, ENVOY, BRAVADA) in Seats.
  18. Install the communication interface module. Refer to Communication Interface Module Replacement (TrailBlazer, Envoy, Bravada)  or Communication Interface Module Replacement (TrailBlazer EXT, Envoy XL) .
  19. Adjust the right seat cushion to a passenger position.
scientia non olet · About LEMON Manuals