Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Use tape on the tool surface so that you do not damage the paint on the antenna mast.

Install the antenna mast to the antenna base.

Fig 1: Installing Antenna Mast To Antenna Base
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Screw the antenna mast to the antenna base.
Tighten

Tighten the antenna mast to 5 N.m (44 lb in).

Fig 2: Screwing Antenna Mast To Antenna Base
Courtesy of GENERAL MOTORS CORP.