LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1575 (Wiper System & Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the wiper arm blade to the wiper arm. Refer to WIPER ARM REPLACEMENT   . 
  2. Position the wiper arm so that the wiper blade aligns with the mark made on the windshield before removal.
  3. Install the wiper arm onto the drive shaft.
    NOTE: Refer to Fastener Notice   in Cautions and Notices.
  4. Install the nut on the drive shaft.

    Tighten 

    Tighten the nut to 30 N.m (22 lb ft).

  5. Install the cover on the nut.
  6. Clean the locating mark or masking tape from the windshield.
  7. Operate the wipers and inspect for proper operation.
    Fig 1: Installing Wiper Arm Blade To Wiper Arm
    G01640623Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals