LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1574 (Lighting Systems) >> Repair Instructions >> Dome and Reading Lamp Bulb Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carefully grasp the sides of the lens to partially expose the rear retaining tab.
  2. Use a flat bladed tool in order to release the rear lens retaining tab.
  3. Lower the rear edge of the lens away from the headliner.
  4. Move the lens rearward in order to release the front horizontal retaining tab.
    Fig 1: Releasing Front Horizontal Retaining Tab
    G01640481Courtesy of GENERAL MOTORS CORP.
  5. Remove the lens from the headliner.
    Fig 2: Removing Lens From Headliner
    G01640482Courtesy of GENERAL MOTORS CORP.
  6. If replacing the reading lamp bulb (1), remove the reflector (2) from the dome lamp.
  7. Remove the reading lamp bulb from the socket.
    Fig 3: Removing Reading Lamp Bulb From Socket
    G01640483Courtesy of GENERAL MOTORS CORP.
  8. If replacing the dome lamp bulb (1), remove the dome lamp bulb from the socket.
    Fig 4: Removing Dome Lamp Bulb From Socket
    G01640484Courtesy of GENERAL MOTORS CORP.