LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Weather Pack Connectors

Weather Pack Connectors

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The following is the proper procedure for the repair of Weather Pack® Connectors.

Fig 1: Separating Connector Halves - Weather Pack Connectors
G01640223Courtesy of GENERAL MOTORS CORP.
  1. Separate the connector halves (1).
  2. Open the secondary lock. A secondary lock aids in terminal retention and is usually molded to the connector (1).
  3. Grasp the wire and push the terminal to the forward most position. Hold the wire in this position.
    Fig 2: Inserting Weather Pack Terminal Removal Tool Into Front (Mating End) Of Connector Cavity
    G01640224Courtesy of GENERAL MOTORS CORP.
  4. Insert the Weather Pack® terminal removal tool into the front (mating end) of the connector cavity until it rests on the cavity shoulder (1).
  5. Gently pull on the wire to remove the terminal through the back of the connector (2).
    IMPORTANT: Never use force to remove a terminal from a connector.
  6. Inspect the terminal and connector for damage. Repair as necessary. .
  7. Reform the lock tang (2) and reset terminal in connector body.
  8. Close secondary locks and join connector halves.
  9. Verify that circuit is complete and working satisfactorily.
  10. Perform system check.
scientia non olet · About LEMON Manuals