LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1572 (Wiring Systems (General Information)) >> Diagnostic Information and Procedures >> Pull to Seat Connectors >> Terminal Removal

Terminal Removal

WARNING: This page is about a different car, the 2003 Oldsmobile Bravada, 2003 GMC Envoy XL, 2003 GMC Envoy, and 2003 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

If the terminal is visibly damaged or is suspected of having a faulty connection, the terminal should be replaced.

Follow the steps below in order to repair pull-to-seat connectors:

Fig 1: Removing Connector Position Assurance (CPA) Device And/Or Secondary Lock
G01640222Courtesy of GENERAL MOTORS CORP.
  1. Remove the connector position assurance (CPA) device and/or the secondary lock.
  2. Disconnect the connector from the component or separate the connectors for in-line connectors.
  3. Remove the terminal position assurance (TPA) device.
  4. Insert the proper pick or removal tool into the front of the connector body.
    IMPORTANT: On connectors with more than one terminal the service loop may not be large enough to remove the terminal and crimp on a new one. If the terminal wire does not have a large enough service loop for removal, cut the wire 5 cm (2 in) behind the connector before removal.
  5. Grasp the wire at the back of the connector body and gently push the terminal (1) out the front of the connector body (3).
scientia non olet · About LEMON Manuals