LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Switch Bezel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the lumbar switch to the switch bezel, verifying that the retaining tabs are fully seated. Refer toLumbar Switch Replacement - Front 
    Fig 1: View Of Bulkhead Connector
    GM752953Courtesy of GENERAL MOTORS CORP.
  2. Install the seat switches to the switch bezel, verifying that the retaining tabs are fully seated. Refer to Seat Switch Replacement - Power 
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the switch bezel to the seat with the 3 screws.

    Tighten:  Tighten the front seat switch bezel screws to 3 N.m (26 lb in).

    Fig 2: Removing/Installing Seat Switch Bezel Retaining Screws
    GM752955Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals