LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat assembly onto the floor studs in the vehicle.
  2. Install the two seat belt anchors onto the floor studs.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the three seat mounting nuts.

    Tighten:  Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).

    Fig 1: Removing/Installing Rear Seat Assembly & Mounting Nuts
    GM828139Courtesy of GENERAL MOTORS CORP.
  4. Install the three seat mounting bolts.

    Tighten:  Tighten the rear seat mounting bolts to 45 N.m (33 lb ft).

scientia non olet · About LEMON Manuals