LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Replacement - Front Bucket >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable SIR. Refer to DISABLING SYSTEM in SIR.
    IMPORTANT: Before removing the seat, ensure that the following conditions are met:
    • For power seats, verify that the seat bottom is fully down.
    • The seat back is in the full upright position.
    • The upper and lower seat rails are flush at rear.
  2. Remove the seat mounting fastener covers.
  3. Remove the 3 front seat mounting nuts.
    Fig 1: Removing/Installing Front Seat Mounting Nuts & Bolts
    GM722607Courtesy of GENERAL MOTORS CORP.
  4. Remove the front seat mounting bolt.
  5. Disconnect the electrical harness. Unclip the harness from the seat bracket.
  6. Remove the seat from the vehicle.
  7. Place the seat on a clean, prepared surface.
scientia non olet · About LEMON Manuals