LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Latch Rod Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat latch rod (1) to the inner and outer riser assemblies.
  2. Install a retainer nut (2) on each end of the seat latch rod (1).
    Fig 1: Removing Seat Latch Rod Retainer Nut
    GM824155Courtesy of GENERAL MOTORS CORP.
  3. Install the seat riser latch assembly (1) to the seat latch rod (2).
    Fig 2: Removing/Installing Seat Latch Rod To Seat Riser Latch Assembly
    GM824156Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two bolts (2).

    Tighten:  Tighten the rear seat cushion bolts to 11 N.m (97 lb in).

    Fig 3: Removing/Installing Rear Seat Cushion Assembly Mounting Bolts
    GM824146Courtesy of GENERAL MOTORS CORP.
  5. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 2 .
scientia non olet · About LEMON Manuals