Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the screws securing the seat cushion trim panel to the seat cushion assembly.
Tighten: Tighten the rear seat cushion trim panel screws to 2 N.m (18 lb in).

Fig 1: Removing/Installing Seat Cushion Trim Panel Retaining Screws
Courtesy of GENERAL MOTORS CORP.
Install the seat cover J-strips (1) to the seat cushion trim panel (2).

Fig 2: Removing/Installing Seat Cover J Strips
Courtesy of GENERAL MOTORS CORP.
Install the two bolts (2) securing the support (1) to the seat cushion trim panel.
Tighten: Tighten the rear seat support bolts to 35 N.m (26 lb ft).

Fig 3: Removing/Installing Seat Cushion Trim Panel Support Mounting Bolts
Courtesy of GENERAL MOTORS CORP.
Install the rear seat bracket with the four mounting nuts (2).
Tighten: Tighten the rear seat bracket mounting nuts to 25 N.m (18 lb ft).

Fig 4: Locating Rear Seat Bracket Trim Covers & Mounting Nuts
Courtesy of GENERAL MOTORS CORP.
Install the rear seat bracket trim covers (1).
Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .