LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat cushion assembly to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the 2 nuts that retain the seat cushion assembly to the floor panel.

    Tighten:  Tighten the rear seat mounting nuts to 45 N.m (33 lb ft).

    Fig 1: Removing/Installing Seat Cushion Assembly & Mounting Nuts
    GM722615Courtesy of GENERAL MOTORS CORP.
  3. Install the hydraulic jack into the jack stowage area, on the left side only.
  4. Adjust the seat cushion assembly to the latched position.
  5. Install the rear mount trim cover.
scientia non olet · About LEMON Manuals