LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Pull Strap Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the small loop (1) onto the rear seat cushion latch (2).
    Fig 1: Removing/Installing Strap From Rear Seat Cushion Latch
    GM753718Courtesy of GENERAL MOTORS CORP.
  2. Install the strap through the opening in the seat pan.
    Fig 2: Removing/Installing Latch Strap Into Seat Pan Opening
    GM753717Courtesy of GENERAL MOTORS CORP.
  3. Install the rear-seat cushion cover and the pad. Refer to Seat Cushion Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Cushion Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
  4. Install the rear seat cushion assembly to the vehicle. Refer to Seat Cushion Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) .
scientia non olet · About LEMON Manuals