LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Panel Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat cushion panel on the pad and cover.
  2. Install the J-strips (2) securing the seat cushion cover to the seat cushion panel.
    Fig 1: Identifying Pull Handle & J-Strips
    GM824148Courtesy of GENERAL MOTORS CORP.
  3. Install the pull handle (1). Refer to Pull Handle Assembly Replacement - Rear No. 2 .
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two rear seat cushion bolts (2).

    Tighten:  Tighten the rear seat cushion bolts to 11 N.m (97 lb in).

    Fig 2: Removing/Installing Seat Cushion Assembly Mounting Bolts
    GM824146Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals