LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the trim panel from the power seat by performing the following:
    1. Remove the 3 seat switch bezel mounting screws. Refer to Seat Switch Bezel Replacement .
    2. Remove the 3 trim panel retaining screws.
      Fig 1: Removing/Installing Power Seat Trim Panel Retaining Screws
      GM752954Courtesy of GENERAL MOTORS CORP.
  2. Remove the trim panel from the manual seat by performing the following steps:
    1. Remove the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    2. Remove the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
    3. Remove the screws from the trim panel.
      4. Fig 2: Removing/Installing Manual Seat Trim Panel Retaining Screws
      GM755843Courtesy of GENERAL MOTORS CORP.
  3. Remove the trim panel from the seat assembly.
scientia non olet · About LEMON Manuals