LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Outer Trim Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the trim panel to the power seat by performing the following steps:
      Fig 1: Removing/Installing Power Seat Trim Panel Retaining Screws
      GM752954Courtesy of GENERAL MOTORS CORP.
      NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    1. Align the trim panel to the seat assembly.
    2. Install the screws retaining the trim panel to the seat assembly.

      Tighten:  Tighten the trim panel screws to 3 N.m (26 lb in).

    3. Install the 3 seat switch bezel mounting screws.

      Tighten:  Tighten the seat switch bezel mounting screws to 3 N.m (26 lb ft).

  2. Install the trim panel to the manual seat by performing the following steps:
      Fig 2: Removing/Installing Manual Seat Trim Panel Retaining Screws
      GM755843Courtesy of GENERAL MOTORS CORP.
    1. Install the screws in the trim panel.
    2. Install the lumbar support knob. Refer to Lumbar Support Knob Replacement .
    3. Install the seat back recliner handle. Refer to Seat Back Recliner Handle Replacement - Front .
scientia non olet · About LEMON Manuals