LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 2 >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the two bolts (2) securing the rear seat cushion assembly (1) to the seat latch rod (3).
    2. Fig 1: Removing/Installing Seat Cushion Assembly Mounting Bolts
    GM824146Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear seat cushion assembly.
  3. Remove the pull handle assembly (1). Refer to Pull Handle Assembly Replacement - Rear No. 2 .
    Fig 2: Identifying Pull Handle & J-Strips
    GM824148Courtesy of GENERAL MOTORS CORP.
  4. Remove the J-strips (2) securing the rear seat cushion cover to the seat cushion panel.
  5. Remove the seat cushion panel from the pad and cover.
  6. Remove the hog rings (1) from the seat cover.
    Fig 3: View Of Seat Cover Hogs Rings
    GM824149Courtesy of GENERAL MOTORS CORP.
  7. Carefully separate the hook and loop fastener strips (2) holding the cover to the pad.
    Fig 4: Locating Hog Rings Hook & Loop Fastener Strips
    GM824170Courtesy of GENERAL MOTORS CORP.
  8. Remove the hog rings (1).
scientia non olet · About LEMON Manuals