LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Rear No. 2 >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the hog rings (1) securing the seat cover to the pad.
  2. Pull the cover over the pad pressing the hook and loop fastener strips (2) together.
    Fig 1: Locating Hog Rings And Hook & Loop Fastener Strips
    GM824170Courtesy of GENERAL MOTORS CORP.
  3. Install the cover flaps to the pad with hog rings (1).
    Fig 2: View Of Seat Cover Hogs Rings
    GM824149Courtesy of GENERAL MOTORS CORP.
  4. Install the seat cushion panel on the pad and cover.
  5. Install the J-strips (2) securing the seat cushion cover to the seat cushion panel.
    Fig 3: Identifying Pull Handle & J-Strips
    GM824148Courtesy of GENERAL MOTORS CORP.
  6. Install the pull handle assembly (1). Refer to Pull Handle Assembly Replacement - Rear No. 2 .
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  7. Install the rear seat cushion assembly (1) to the seat latch rod (3) with two bolts (2).

    Tighten:  Tighten the seat cushion bolts to 11 N.m (97 lb in).

    Fig 4: Removing/Installing Seat Cushion Assembly Mounting Bolts
    GM824146Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals