LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Cover and Pad Replacement - Front >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 seat switch bezel screws. Refer to Seat Switch Bezel Replacement .
  2. Remove the 4 nuts that retain the seat pan to the seat adjuster assembly.
    Fig 1: View Of Underside Of Seat Adjuster Frame & Mounting Nuts
    GM752864Courtesy of GENERAL MOTORS CORP.
  3. Remove the clip from the front outboard seat pan stud, if equipped. Discard the clip.
  4. Release the J strips (1,3) on each side of the seat cushion.
    Fig 2: Locating J Strips
    GM752956Courtesy of GENERAL MOTORS CORP.
  5. Release the front/rear J strips (2,4).
  6. Remove the SIR electrical harness (2) from the seat pan.
    Fig 3: Identifying Connectors & Harness
    GM752865Courtesy of GENERAL MOTORS CORP.
  7. Remove the seat electrical harness from the seat pan.
  8. Remove the wire harness fasteners from the seat pan.
  9. Disconnect the seat cushion heater electrical connector, if equipped.
    IMPORTANT: When separating the seat cover hook and loop retaining strips, do not pull the adhesive-backed strip from the seat pad.
  10. Separate the hook and loop retaining strips.
  11. Remove the hog rings (1) from the bottom rear side of the cover.
    Fig 4: Identifying Bottom Rear Side Hog Rings
    GM752959Courtesy of GENERAL MOTORS CORP.
  12. Remove the 11 hog rings from the top side of the cover.
  13. Remove the seat cushion trim cover and pad from the seat frame.
  14. Remove the seat module retaining screw, if equipped.
    Fig 5: Removing/Installing Seat Module Retaining Screw
    GM752957Courtesy of GENERAL MOTORS CORP.
  15. Remove the seat module, if equipped.
  16. Remove the seat cover from the seat cushion.
  17. Remove the seat cushion from the seat pan.