LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Cushion Bracket Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the rear seat cushion bracket to the seat cushion bottom with the four mounting nuts (2).

    Tighten:  Tighten the rear seat cushion bracket mounting nuts to 25 N.m (18 lb ft).

    Fig 1: Removing/Installing Rear Seat Bracket Trim Covers & Nuts
    GM828144Courtesy of GENERAL MOTORS CORP.
  2. Install the rear seat bracket trim covers (1).
  3. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) .