LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Replacement - Rear No. 1 (TrailBlazer, EXT, Envoy XL) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the screws from the inboard/outboard rear seat back cushion hinge covers.
    Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear seat belt anchor nut (2).
    Fig 2: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  3. Remove the seat back cover and pad high enough to expose the seat back cushion mounting bolts. Refer toSeat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
  4. Remove the seat back mounting bolts (2) securing the rear seat back frame to the inboard/outboard rear seat back cushion hinge assembly.
    Fig 3: Removing/Installing Seat Back Mounting Bolts
    GM828223Courtesy of GENERAL MOTORS CORP.
  5. Remove the seat back assembly.
scientia non olet · About LEMON Manuals