LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Replacement - Rear No. 1 (TrailBlazer, EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
    Fig 1: Removing/Installing Seat Back Mounting Bolts
    GM828223Courtesy of GENERAL MOTORS CORP.
  1. Install the seat back cushion mounting bolts (2) securing the rear seat back frame to the inboard/outboard rear seat back cushion hinge assembly.

    Tighten:  Tighten all rear seat back cushion mounting bolts to 25 N.m (18 lb ft).

  2. Install the rear seat belt anchor nut (2).

    Tighten:  Tighten all rear center seat belt anchor nut to 60 N.m (44 lb ft).

    Fig 2: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back cover and pad to the seat back. Refer toSeat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .
  4. Install the inboard/outboard rear seat back cushion hinge covers with the three screws.

    Tighten:  Tighten the seat back cushion hinge cover screws to 2 N.m (18 lb in).

    Fig 3: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals