Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the release cable to the release latch.

Fig 1: View of Seat Back Release Latch Cable
Courtesy of GENERAL MOTORS CORP.
Install the release latch to the seat frame by pressing the latch into the seat frame until the locking tabs are fully engaged.

Fig 2: Compressing Lower Locking Tabs On Release Latch
Courtesy of GENERAL MOTORS CORP.
Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Back Cover and Pad Replacement - Rear No. 1 (Trailblazer EXT, Envoy XL) .