Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Install the seat back over the top of the seat-back frame.

Fig 1: Removing/Installing Seat Back Panel
Courtesy of GENERAL MOTORS CORP.
Install the panel to the seat-back frame with 2 push-pin fasteners (1) to each side of the panel.

Fig 2: Locating Seat Back Panel Push-Pin Side Fasteners
Courtesy of GENERAL MOTORS CORP.
Install the push-pin fastener (1) to the bottom of the panel.

Fig 3: Identifying Seat Back Panel Push-Pin Bottom Fastener
Courtesy of GENERAL MOTORS CORP.
Install the lumbar cables to the panel clips.

Fig 4: View Of Lumbar Cables & Clips
Courtesy of GENERAL MOTORS CORP.
Install the front seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front .
Install the front bucket seat assembly to the vehicle. Refer to Seat Replacement - Front Bucket .