LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1571 (Power Seat System) >> Repair Instructions >> Seat Back Latch Bracket - Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Oldsmobile Bravada, 2002 GMC Envoy XL, 2002 GMC Envoy, and 2002 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the latch bracket to the seat hinge.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the latch bracket bolts (2) that retain the latch bracket to the seat hinge.

    Tighten:  Tighten the latch bracket bolts to 35 N.m (26 lb ft).

    Fig 1: Removing/Installing Latch & Hinge Bracket Mounting Bolts
    GM753533Courtesy of GENERAL MOTORS CORP.
  3. Install the seat back to the vehicle. Refer to Seat Back Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada)  or Seat Back Replacement - Rear No. 1 (TrailBlazer, EXT, Envoy XL) .
scientia non olet · About LEMON Manuals